Unless of course, that's all been precoordinated. It's OK as long as they're not in the same place at the same time. I have to crack the set up between the two but as a noob, it's easier to have one box doing one thing at one time for one reason. I want that firewall out front to do it's thing, than the DMZ, than the router with it's own (built in) firewall doing it's thing. The future DMZ thing is really the main goal. Most of all, at some point in the future, I'd like to set up a DMZ between the two so they'll be separate doing their own thing anyway so I'm just setting that split and right from the get go. DD-WRT offers Access restrictions per IP or MAC address, blocking P2P and other applications or website and it's super easy with dd-wrt, QoS, priority per IP, MAC, subnet or application, and the hotspot options. Perhaps when I start to push a lot of throughput on the router, DD-WRT will fold (like some have reported) but for me, it's been rock solid. Again, pfSense will be a stand alone firewall directly after the modem, then the router will be handling all the DHCP, wireless AP, access restrictions, etc.Įventually, if at all possible, (and after I'm much more network competent, I'd like to set up a DMZ either with the DD-WRT or another stand alone box but for now, I'm just trying to get the router back into the chain so I can get my home network back in the game.Īny advice or suggestions greatly appreciated.ĭon't get me wrong, in the very short time I'm looking at pfSense in the box I just set up, it's amazing with all the options that thing can handle. There were half a dozen other options that looked like I should start checking or unchecking but then I realized, I wasn't going to learn anything that way and really wouldn't appreciate what's going on or understand how to fix it if it went down.Ĭan anyone provide a basic listing of the steps I should be focusing on to set the router up to serve in this new capacity? What settings should I changing or testing out so I make a good connection to the pfSense firewall? I'm sure the firewall is set on a fixed IP. I think I need to change the settings from Gateway to Router (under advanced routing) but I'm just guessing (the noob at large). They also suggested turning off DHCP in DD-WRT but I want the router to handle handing out DHCP addresses. One guide suggested putting both boxes on the same subnet but I think that's incorrect. I've checked the net for info but found it very spotty or not truly relevant to my specific situation. The goal is to have pfSense box as just pure firewall, put the router (Cisco/Linksys WRT160NL running DD-WRT v24-sp2) down line from that for routing, wireless AP, etc. I have the pfSense box setup and running as a firewall only with a single machine and it checks out good. In other words, I have a clue but I know just enough to be dangerous. My background is IT help desk so networking is not my forte but again, I can listen and follow advice. ![]() I'm technically a noob but I am competent enough to flash my router with DD-WRT, setup a FreeNAS box, and just last night, with a little help from the guys on the pfSense forum, I setup a pfSense stand alone firewall. I'm asking for technical advice with some networking issues directly related to DD-WRT.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |